• 검색 결과가 없습니다.

Finite element analysis of the effects of a mouthguard on stress distribution of facial bone and skull under mandibular impacts

N/A
N/A
Info
다운로드
Protected

Academic year: 2021

Share "Finite element analysis of the effects of a mouthguard on stress distribution of facial bone and skull under mandibular impacts"

Copied!
1
0
0

로드 중.... (전체 텍스트 보기)

전체 글

(1)

http://dx.doi.org/10.4047/jkap.2012.50.3.217

ERRATUM

대한치과보철학회지 2012년 50권 3호 217

Erratum to:

J Korean Acad Prosthodont 2012;50:1-9 (http://dx.doi.org/10.4047/jkap.2012.50.1.1)

There has been a mistake, claimed and confirmed by all the authors of Vol 50(1), 2012, p. 1-9 issue, that first author should have been Il-Han Kim instead of Kwan-Tae Noh.

Corresponding Author: Dae-Gyun Choi

Department of Prosthodontics, School of Dentistry, Kyung-Hee University, #1, Hoegi-Dong, Dongdaemun-Gu, Seoul, 130-701, Korea +82 2 958 9340, Email: choi@khu.ac.kr

Finite element analysis of the effects of a mouthguard

on stress distribution of facial bone and skull under mandibular impacts

Il-Han Kim, DMD, MSD, PhD, Kwan-Tae Noh, DMD, MSD, PhD, Hyun-Sik Roh, DMD, Ji-Yeon Kim, DMD, Yi-Hyung Woo, DMD, MSD, PhD, Kung-Rock Kwon, DMD, MSD, PhD, Dae-Gyun Choi*, DMD, PhD

Department of Prosthodontics, School of Dentistry, Kyung Hee University, Seoul, Korea

참조

지금 다운로드하기 ( PDF - 1 페이지 - 165.34 KB )

관련 문서

저작자표시

In this study, the finite element analysis was used to predict and obtain the material properties of the carbon fibers and the resin even if the carbon fiber laminate and the

저작자표시

This study was performed to confirm the effect of the stress distribution on short implant supporting bone according to horizontal bone loss using a three-dimensional

저작자표시

12 As such, using finite element modeling, the effect of stress distribution around the internal non-submerged type implants on marginal bone resorption

저작자표시

It is possible to control the welding residual stress and deformation through the finite element analysis using jig free in-situ control technique of welding induced out

조선대학교 대학원

Evaluating parameters of osseointegrated dental implants using finite element analysis-a two- dimentional comparative study examining the effects of implant

Micro-CT 영상을 이용한 치아 3차원 모델링 및 유한요소분석에의 적용

The optimized STL files of the 3D tooth models were imported into the finite element analysis software, CosmosWorks (Structural Research & Analysis

Rock Mechanics and Rock Engineering Laboratory

San 56-1 Shilim-dong Gwanak gu Gwanak-gu Seoul, 151-744 Korea +82-2-880-8807

저작자표시

2. The finite element is calculating using tension test of uni-direction 0° and 90°, compression test of uni-direction 0° and 90° and shear test results and, the results