• 검색 결과가 없습니다.

Nitride Phosphors for the Better Performance of WLEDs

N/A
N/A
Protected

Academic year: 2021

Share "Nitride Phosphors for the Better Performance of WLEDs"

Copied!
1
0
0

로드 중.... (전체 텍스트 보기)

전체 글

(1)

4-1 / C. Yoon

IMID 2009 DIGEST •

Nitride Phosphors for the Better Performance of WLEDs

Chulsoo Yoon

R&D Institute, Samsung LED Co., Suwon, Kyunggi-do, Korea

Phone: +82-31-210-6825, E-mail: [email protected]

Abstract

Phosphors with oxide host material, YAG:Ce3+ and (Ca,Sr,Ba)

2SiO4:Eu2+ yellow phosphor, has

been used for LED applications. The WLEDs using these phosphors are widely used for LCD backlighting, automobile, and general lighting applications since they have high conversion efficiency and good thermal and chemical stability which can meet necessary life time of LED products up to now. With advances of LED chip technology, the external quantum efficiency and driving current in chip get higher so that the phosphors for high power chip are required to maintain high conversion efficiency and stability at high temperature due to the heat dissipated from LED chips. In addition, higher color rendering index of LED lighting and color reproducibility of LCD than those of LEDs with single yellow phosphors are required. In order to overcome these technical issues rising from evolution of LED technology, new phosphors are in demand and nitride phosphors, one of the promising new candidate materials, will be discussed here.

참조

관련 문서

Buyers represent that they have all necessary expertise in the safety and regulatory ramifications of their applications, and acknowledge and agree that they are solely

Since then, many research applications of 10 Be for both terrestrial and extraterrestrial applications have been developed, which parallel the wide range

Magnesium alloys that derive their strength from precipitation hardening are usually considered the most promising for such applications and the thermal stability of

this study analysed cast speed and solidification in thermal and flow perspectives and based on the results, conducted a confidence test on the high-speed general purpose

Martonosi, "Dynamic thermal management for high- performance microprocessors," Proceedings of International Symposium on High-Performance Computer

This work builds inversely a base performance model of a turboprop engine to be used for a high altitude operation UAV using measured performance data,

Since no direct process data have been provided for these units, the emissions should be estimated from the general emission factors listed in

Where FPSO substructure costs have been estimated, these have been based on the lightship weight determined and using the same cost basis as the FSO hull. Costs for swivel,