Wk13:형식화된 이론들.pdf
Low-Cost CRC Scheme by Using DBI(Data Bus Inversion) for High Speed Semiconductor Memory
Design of Roll-to-Roll Forming Process for Micro Pattern on the Thin Sheet Metal by Finite Element Analysis
Internal Defect Minimization of Die Cast Impeller Blade Using Taguchi's Design of Experiment
Implementation of a High Efficiency SCALDO Regulator Using MOSFET
Investigation of Deep Drawability and Product Qualities of Ultra Thin Beryllium Copper Sheet Metal
A Study on Development of Voice and SMS Alarm System Based on MODBUS Protocol
A Study on Development of Conversion Software for Controller Without OPC Stack to Communicate With OPC DA Client
A Study on the Structural Analysis for Plastic Door Handle of Automobile
Design and Implementation of Publish/Subscribe Model Based RPC Middleware
감속 시의 고정부 작용력 측정을 이용한 반작용휠 계의 가진 입력 특성 규명
A Propose of Design Parameters for the Max. Speed of 250 km/h of Overhead Rigid Conductor System
A Correcting Method of the GPS Location Information using one CCTV in Smart Care Surveillance System
Performance Comparison of Vertical DMOSFETs in Ga<sub>2</sub>O<sub>3</sub> and 4H-SiC
토질역학_15장_사면안정
Investigation of Micro Cutting Characteristics for Tungsten-Carbide Green Part
An Implementation of High-precision Three-phase Linear Absolute Position Sensor
Design of FIR Filters With Sparse Signed Digit Coefficients
A Study on the Fabrication of Nano-Pattern Mold Using Anodic Aluminum Oxide Membrane
Improvement Method for Message Processing Speed of ADC2A System
Design Technique and Application for Distributed Recovery Block Using the Partitioning Operating System Based on Multi-Core System
An Optimum Design of Pipe Bending Process Using High Frequency Induction Heating and Dynamic Reverse Moment
Alternating Battery Discharge Method Using Discharge Time Balancing
Woo-Geun Lee, Dong-Ho Kang, Yeong-Mu Ko*
