• 검색 결과가 없습니다.

HPLC and Laser Nebulizers

N/A
N/A
Protected

Academic year: 2022

Share "HPLC and Laser Nebulizers"

Copied!
1
0
0

로드 중.... (전체 텍스트 보기)

전체 글

(1)

Elemental Scientific Inc. 2008 Catalog

www.icpms.com Phone: 402.991.7800

sales@icpms.com 3 Fax: 402.991.7799

PFA-LS Laser Ablation Nebulizer

Many laser ablation studies involve the introduction of a liquid standard aerosol for performing mass calibrations, ICP optimization etc.

The PFA-LS has been designed so that it produces a fine aerosol at low nebulizer gas flow rates (0.2—0.3L/min) allowing more sample gas to pass through the laser ablation chamber.

HPLC and Laser Nebulizers

i.d. self-aspiration rate (@1L/m Ar) ES-2020-2000 PFA-20 20 µL/min ES-2000-2000 PFA-50 50 µL/min

ES-2002-2000 PFA-100 100 µL/min ES-2003-2000 PFA-200 200 µL/min ES-2005-2000 PFA-400 400 µL/min

ES-2050 PFA-LC Nebulizer

PFA-LC for Liquid Chromatography

The PFA-LC nebulizer has a smaller internal capillary than the standard ST type nebulizers.

The small dead volume (<3µL) reduces band broadening effects, once a peak leaves the column.

Supplied with common HPLC fittings for zero dead volume connections to the HPLC system.

Suitable for both micro and standard flow chromatography.

ES-2046-0001 Obstruction removal kit ES-2046-0003 Replacement guide for

obstruction removal kit ES-2046-0002 10 piece fused silica refill for

obstruction removal kit ES-2010 Silica, 50µm i.d. x 650mm ES-2012 Silica, 75µm i.d. x 650mm

Designed specifically for PFA-ST and PolyPro-ST nebulizers to remove clogs. Includes one guide, 10 pieces of fused silica and instructions. For use with ST type nebulizers only. Not necessary for High Solids nebulizers.

Obstruction Removal Kit

(red) (purple) (green) (yellow) (orange)

ODLAB(오디랩) 판매담당자:엄영록(HP:011-695-4916)TEL:02-809-7848

참조

관련 문서

The gas holdup has been obtained from the pressure drop profiles by means of static pressure drop method, and the axial dispersion coefficient of liquid phase and

SEM image of the GaN film grown on Si(100) substrate at room temperature by reactive laser ablation of liquid Ga metal target in ammonia atmosphere (50 mTorr).

Large polyynes with n &gt; 5, in particular, have been prepared by laser ablation of graphite mostly in organic solvents, while we present experimental results on

After further process optimization, such as shortening of sample line from laser ablation setup to ICP-MS in order to remove the dispersed tailing in the mass spectrum,

According to the results of this study, when low power laser was applied to rat models with sciatic nerve crush injury for 21 days and the results were examined through

The KORONA TM GLTP/LTP series using DPSS laser and XeCl excimer laser is designed for the new generation of the wafer &amp; FPD glass annealing processing

reaction intermediate becomes more ionic in nature, the ste ­ reochemistry of the halogen addition has been found to change so that either c , s-addition to the olefin or

In order for stimulated emission to be more likely to occur than absorption, so that there is a net increase in the number of photons traveling through the amplifier, more atoms