Measurements of Micro-Defects in the Aluminum Thixoformed Part using Computed Tomography(CT) Technology
전체 글
수치
관련 문서
1 John Owen, Justification by Faith Alone, in The Works of John Owen, ed. John Bolt, trans. Scott Clark, "Do This and Live: Christ's Active Obedience as the
In the simple frequency analysis, TF-IDF analysis, and Topic analysis results, the meaning and social impact of future transport technology are explored, and
In this study, the different codes were compared and analyzed for the research on decontamination and decommissioning waste generation by using the codes
Fourth, as the information technology is developed due to the fourth industrial revolution and the proportion of information technology in the commercial
Third, direct tensile strength tests showed that tensile performance appeared to be higher in cases where fiber volume fraction was high and in cases of 1% fiber volume
From the results of Micro Vickers hardness test, Ti- 40Hf alloy showed significantly increasing of hardness and tensile strength than others in the case of
The average tensile strength value before heat treatment of PLA output was 9.67 N/㎟, and the average tensile strength value after heat treatment was 24.17 N/㎟, which
In the present study, as a preliminary study, a LACC-based Compton CT was developed to estimate the activity of the spot inside the radioactive waste drum. To