• 검색 결과가 없습니다.

Sinus augmentation using rhBMP-2-loaded synthetic bone substitute with simultaneous implant placement in rabbits

N/A
N/A
Protected

Academic year: 2021

Share "Sinus augmentation using rhBMP-2-loaded synthetic bone substitute with simultaneous implant placement in rabbits"

Copied!
10
0
0

로드 중.... (전체 텍스트 보기)

전체 글

Loading

수치

Figure 1.  (A) Photograph of the implant used in this study. (B) Two implant sites and holes were prepared  bilaterally
Figure 2.  Schematic showing the measured parameters.
Figure 4.  Histological photomicrographs of the total augmented area after 4 weeks of healing
Figure 5.  Histological photomicrographs of the apical area after 4 weeks of healing. (A) BMP group

참조

관련 문서

3 Mean percentages of bone implant contact ratio in the control group and experimental groups at 6 and 12 weeks after placement of the

Methods to overcome insufficient bone due to poor bone quality, the pneumatization of a maxillary sinus and other anatomical limitations of implant placement

Histopathologic findings of control group at 4 weeks show little bone- implant contact (BIC) around the implant (asterisks) and new-bone formation in the defect

캐나다정부간행물목록(Weekly checklist of Canadian government publications) 에 수록된 자료 중 Folder자료, 인구센서스, 전화번호 자료 등을 제외한

The grafted particulated tooth driven allografts were partially surrounded with new bone matrix and fairly supported graft associated new bone formation with some

Alveolar ridge augmentation with titanium mesh and a combination of autogenous bone and anorganic bovine bone: a 2-year prospective study.. Corinaldesi G, Pieri F, Sapigni

The aim of this study was to compare the effect on bone regeneration relative to maintenance period of PTFE membrane in rabbit calcarial defects.. Eight adult

The OSFE (osteotome sinus floor elevation) technique has been used for maxillary sinus augmentation.. The implants were clinically and radiographically followed