• 검색 결과가 없습니다.

Autogenous tooth bone graft block for sinus augmentation with simultaneous implant installation: a technical note

N/A
N/A
Protected

Academic year: 2021

Share "Autogenous tooth bone graft block for sinus augmentation with simultaneous implant installation: a technical note"

Copied!
6
0
0

로드 중.... (전체 텍스트 보기)

전체 글

Loading

수치

Fig. 3. The sinus lateral window was opened and the membrane  was elevated.
Fig. 6. The implant was simultaneously installed through the al- al-veolar bone and into the autogenous tooth bone graft block.
Fig. 11. The occlusal view of the autogenous tooth bone graft  block.
Fig. 13. The lateral sinus window opening and the preparation of  the implant site on the alveolar bone.
+2

참조

관련 문서

Histopathologic findings of control group at 4 weeks show little bone- implant contact (BIC) around the implant (asterisks) and new-bone formation in the defect

Conclusions : The mesiodens and the 3rd molar teeth are very similar to the inorganic component. These results provide reasonable rationale that mesiodens can be used

The grafted particulated tooth driven allografts were partially surrounded with new bone matrix and fairly supported graft associated new bone formation with some

Alveolar ridge augmentation with titanium mesh and a combination of autogenous bone and anorganic bovine bone: a 2-year prospective study.. Corinaldesi G, Pieri F, Sapigni

The OSFE (osteotome sinus floor elevation) technique has been used for maxillary sinus augmentation.. The implants were clinically and radiographically followed

success rates of dental implants placed at the time of or after alveolar ridge augmentation with an autogenous mandibular bone graft and titanium mesh: a 3-to

In 4-week group, the group filled with bone graft with decortication revealed larger new bone formation area than shown in the group that had a defect area

Higher power view of the box area of the left figure showed poor new-bone formation around the implant (asterisk) and low BIC. Villanueva