Pop-up Card (Santa Claus) : Assembly Instructions
Canon is a registered trademark of Canon Inc.
1
Caution:Glue, scissors, and other tools may be dangerous to young children so be sure to keep them out of the reach of young children.
Valley fold
(dashed and dotted line)
*Make a valley fold.
Scissors line(solid line)
*Cut along the line.
Cut in line(solid line)
*Make a cut.
Black triangle Glue here
Mountain fold(dotted line)
*Make a mountain fold.
Assembly Instructions
scissors, paste, a used ballpoint pen (tracing along the fold lines makes them easier to fold)
You will need You will need
White triangle Glue the back
Cut out the parts and crease them along the fold lines indicated.
Tape Tape
Reindeer and Sleigh
Supports B
Supports C
Tree Sled(front)
Sled(back)
Supports A Reins
Santa Claus
Sky
Hills
Base Front cover Back cover
Decorations
2
Attach Santa Claus to the sleigh (back).
From the tip of the reindeer's front hooves,cut out the section below the trunk and attach tape to the hooves from behind.
Attach the reins to the reindeer and sleigh. Attach assembly 5 and sleigh (front) to the reindeer and sleigh.
Attach the sleigh (front) and Santa Claus together.
*Fold the assembly over as you attach the glue.
Attach Santa Claus to the sleigh (rear).
Pop-up Card (Santa Claus) : Assembly Instructions
Canon is a registered trademark of Canon Inc.
Turn assembly 10 over and attach glue to the spot circled in red.
*Fold the assembly over as you attach the glue.
Attach support A and the reindeer and sleigh to attachment 7.
*Fold the assembly over as you attach the glue.
Attach assembly 8 to the tree stand.
Attach support B to assembly 11.
Face assembly 12 forwards and attach the decorations.
Assemble the tree and fold it over.
Pop-up Card (Santa Claus) : Assembly Instructions
Canon is a registered trademark of Canon Inc.
3
Attach the spot circled in red on assembly 13 to the base card.
Attach support C to the sky.
Attach the sky and hills to the base card.
Paste the colored front cover onto the back of the left hand side of the base.
Attach the spot circled in red on assembly 13 to the base card and then attach the hills to assembly 13. Fold over and attach the sky supporter and hills.
Finally, paste the back cover onto the back of the right hand side of the base.
Pop-up Card (Santa Claus) : Assembly Instructions
Canon is a registered trademark of Canon Inc.
