• 검색 결과가 없습니다.

Effect of the restorative technique on load-bearing capacity, cusp deflection, and stress distribution of endodontically-treated premolars with MOD restoration

N/A
N/A
Protected

Academic year: 2021

Share "Effect of the restorative technique on load-bearing capacity, cusp deflection, and stress distribution of endodontically-treated premolars with MOD restoration"

Copied!
12
0
0

로드 중.... (전체 텍스트 보기)

전체 글

Loading

수치

Figure 1. Schematic illustration of the modeled structures used in this study. The groups were distributed according to the restorative modality: (A) GIC group,  glass ionomer cement + composite resin; (B) MP group, metallic post + composite resin; (C) FGP
Figure 2. Cusp deflection analysis. (A) Strain gauges were bonded to each tooth to evaluate the cusp deflection;
Table 1. Mechanical properties of the materials/structures used in the present study
Figure 5. Results of maximum principal stress (MPa) in the root dentin and post according to the restorative  modality: (A) GIC group, glass ionomer cement + composite resin; (B) MP group, metallic post + composite resin;
+2

참조

관련 문서

c-factor와 관련한 재료적인 영향,즉 modulusofelasticity가 수축 응력에 임상 적으로 영향을 줄 수 있는지를 평가하기 위해 c-factor를 각각 3.7과 1의

In the analysis of soluble solids, the treatment group with material grains and the combined groups of glutinous millet and barley appeared high, and

The effect of flowable resin composite on microleakage and internal voids in class II composite restorations.. Roberts HW, Charlton DG,

This study has undertaken the theoretical contemplation on the bearing capacity calculation method of the bored precast pile foundation, and use the

The aim of this study is to identify some effective actual culture teaching methods or techniques through analyzing the cultural contents and materials of

The purpose of this study was to evaluate the microleakage of composite resins(Filtek ™ Z250), resin-reinforced glass ionomer cements (Fuji II LC ® ), and traditional

The preparation of osseodensification technique should start with a smaller diameter than conventional technique because of the recovery of elastic strain. It

-another type of stereoisomer when Compound having carbon (chiral carbon) with 4 different groups attached carbon (chiral carbon) with 4 different groups