• 검색 결과가 없습니다.

Fault Current Limitation by a Superconducting Coil with a Reversely Magnetized Core for a Fault Current Controller

N/A
N/A
Protected

Academic year: 2021

Share "Fault Current Limitation by a Superconducting Coil with a Reversely Magnetized Core for a Fault Current Controller"

Copied!
5
0
0

로드 중.... (전체 텍스트 보기)

전체 글

Loading

수치

Fig. 3. Test results for a DC reactor coil with (a) air-core, (b) iron-core without RMB, (c) RMC using PMs
Fig. 5. Test results for RMC using an EM in case of 2 Ω  load resistance; (a) RMB coil current of 5A, (b) 8A
Fig. 8. Relative permeability vs. magnetic flux density.

참조

관련 문서

3-43 The Fault Current and Voltage Curves of Fault Phase During the Double Line to Ground Fault(A Transformer for Voltage Drop or Modifier)..

Some important provisions include all commercial buildings are included in the application of the Act, lessors should make contract a new tenant who is recommended by

The similar current transient of a potential step to the RC circuit problem will be obtained for that of the IPE.. 1.2.4 Double-Layer Capacitance and Charging

(3.12), dilution increases for higher perpendicular currents (Alternating diffuser).. Use a perpendicular current of 0.25 m/s and a parallel current. Assume uniform

Table 3-4 Design parameters of the superconducting resonance coil according to the number of turns ··· 16.. Table 3-5 Inductance and capacitance value by the number of

In this paper, the variable capacitors and the superconducting relay antenna were applied to the superconducting WPT system to increase efficiency and the transmission distance

A Study on the Wireless Power Transmission of magnetic resonance using Superconducting

The rectifier is a circuit that acts as a dc voltage source by converting the ac voltage from a standard wall outlet to a dc voltage. This voltage is effectively applied