• 검색 결과가 없습니다.

Heat-Generating Behavior of SiC Fiber Mat Composites Embedded with Ceramic Powder for Heat Conservation

N/A
N/A
Protected

Academic year: 2021

Share "Heat-Generating Behavior of SiC Fiber Mat Composites Embedded with Ceramic Powder for Heat Conservation"

Copied!
6
0
0

로드 중.... (전체 텍스트 보기)

전체 글

Loading

수치

Fig. 1. X-ray diffraction pattern of purchased porphyry and reference materials.
Figure 3 shows the XRD pattern of the SiC fiber fabri- fabri-cated at 1300°C for 2 h in an inert atmosphere and the  pur-chased ceramic powder
Fig. 5. (a) Heating rate depending on the interaction with microwave and (b) cooling rate after switching off the microwave power of SiC fiber mat and SiC fiber mat composite.

참조

관련 문서

For this, the amount of deformation of welded specimens has been measured and compared, which fabricated under four kinds of welding conditions such as

High heat transfer coefficient High thermal conductive material coatings.. Can reduce the constriction resistance

 Heat sink, provides large surface area to dissipate heat from

For this reason, in this study, comparing the traditional manufacturing process and relatively high temperature of exhaust gas heat and CO2 laser

Usually, the initial behavior of effluent through outfall system is rising toward the surface due to mixing with ambient water for heat discharge and sinking toward the bottom

• Heat conduction with a electrical heat source, a nuclear heat source, a viscous heat source, and a chemical heat source.. • Heat conduction

However, the short beam strength of the basalt fiber reinforced composites was higher than those of the glass fiber reinforced composites in the case of the Vacuum

First, computational fluid dynamics(CFD) analysis were used to predict the heat transfer and pressure drop characteristics of each plate heat exchanger with snake